1. TUV. FDA, CE, ISO13485; ISO9001 Approved.
2. No. 1 Production & Sales Amount in China.
3. Export to 28 countries
4. Free Samples
Kangda Brand orthopedic casting tape which is one new medical bandage substitutes of the plaster bandage /P. O. P bandage is used for orthopedic shaping /moulding, which consists of a knitted fiberglass fabric and water-activated polyurethane resin.
Characteristics
It is one new substitute of the traditional plaster bandage
Character of new medical bandage(orthopedic casting tape )
Be used in orthopedic molding and fixing
1 Molding fast
It begin to mold after opening the package and inmmersing into the water, 20 mins later, it can bear weight, but the plaste bandage need more hours for the complete molding.
2 High hardness and light weight
More than 20 times harder, 5 times lighter and use less than the traditional plaster bandage
3 Good air permeability
Unique knitted net stucture make the bandage many holes in the surface to keep good air ventilation and prevent skin damp, hot&pruritus.
4 Excellent X-ray radiolucence
Excellent X-ray radiolucence make it convenient to take X-ray photos and to check the bone healing without removing the bandage, or the plaster need do remove it.
5 Water-proof
The mositure absorbed percent is 85% less than plaster bandage, even on the
Situation of the patient touching the water, it still can keep dry in the injured part.
6 Environment friendly
Material are environmental friendly, which can not produce polluted gas after being burn down.
7 Simple operatinon
Can be done under the room remperature and use the room temperature water and doctor can complete the operation in short time.
8 Can be used in first -aid
Specification and Size
2in KD002 5.0 cm× 360cm 10Rolls/Box
3in KD003 7.5 cm× 360cm 10Rolls/Box
4in KD004 10.0cm× 360cm 10Rolls/Box
5in KD005 12.5cm× 360cm 10Rolls/Box
6in KD006 15.0cm× 360cm 10Rolls/Box
Operation
1. Put on the padded covering in the affected body part, and twine with the cotton paper.
2. Wear surgical gloves.
3. Before opening the package, choose the roll of proper size.
4. Immerse the roll in room temperature water for 2-3 seconds and squeeze it 2-3 times.
5. Wrap spirally, overlapping the previous layer by one-half or two-thirds the width of the roll. Just 3-4 layers provide a strong non-weight-bearing cast and 5-6 layers are typically adequate for weight-bearing cast.
6. KangdaCast is sufficiently cured to pervert further molding in 3-5 minutes after immersion in the water. Allow about 10 minutes for sufficient cure and let patients do not move during this time.
7. KangdaCast may be windowed, trimmed or removed with traditional cast saw equipment.
Precaution
Please apply the surgical rubber gloves when you operate the product.
When the resin is stuck to operator, please wipe it out with cotton swab with acetone.
Recommended Amount of Usage
Size Use
2in Childrens hands, fingers, and toes
3in Childrens wrists, ankles, and arms and legs
4in Childrens legs and ankles, adults hands and wrists
5in Adults arms and legs
6in Adults arms and legs
Storage
Be careful not to break the package.
Store KANGDA Cast at room temperature.
Damaged products by careless handing cannot be replaced. Please handle and store them carefully.
The shelf life of KANGDA Cast is 3 years from the day of production.
){kind=link}